打破while循环并重新启动代码

Question

我想知道是否可以在不使用MCU复位引脚上的外部复位按钮的情况下中断while循环并从特定位置重新启动代码.

下面是我希望在"if"语句为真时打破的while循环,我正在使用LCD并希望返回到我的代码中显示文本的特定部分(模仿主页).

实际上,当"if"语句为真时,while循环被破坏并且代码结束.

int main(void)
{
    /***************************************** BUTTON CONFIGURATION ********************************/

    DDRA &= ~((1<<PINA0) | (1<<PINA1) | (1<<PINA2) | (1<<PINA3));   // Config pins as inputs (ADC3 - Matching with ADMUX assignment below in ADC configuration)

    DDRC = 0xFF;        // Output pins for LEDs

    PORTA |= (1<< PINA0) | (1<<PINA1) | (1<<PINA2); // Three pins for three push buttons

    /****************************************** ADC CONFIGURATION **********************************/

    ADMUX |= (1<<MUX0) | (1<<MUX1) | (1<<REFS0);        // ADC3 and Internal voltage as reference voltage

    MCUCR &= ~((1<<ADTS2) | (1<<ADTS1) | (1<<ADTS0));   // Free running mode

    ADCSRA |= (1<<ADEN) | (1<<ADATE) | (1<<ADIE);   // ADC, Auto trigger source enable and start conversion

    sei();  // Enable global interrupts

    /***************************************** LCD CONFIGURATION ***********************************/

    LCD_Data_DDRB |= (1<<LCD_D7) | (1<<LCD_D6) | (1<<LCD_D5) | (1<<LCD_D4);     // Set output lines for lower 4 bits 

    LCD_Data_DDRD |= (1<<LCD_B3) | (1<<LCD_B2) | (1<<LCD_B1) | (1<<LCD_B0);     // Set output lines for upper 4 bits 

    LCD_Control_DDRB |= (1<<RS) | (1<<RW) | (1<<EN);                // Set RS, RW & EN output lines

    /******************************************** START CODE **************************************/

    LCD_Initialise();   // Run function to initialize the LCD

    LCD_startup();      // Run function which displays default start up text

    ADCSRA |= (1<<ADSC);    // Start conversion

    LCD_Send_Command(DISP_CL);

    while(1)
    {   

      if(Default > Final) 
      {
        LCD_Send_Command(DISP_CL);
        LCD_Send_Command(DISP_CS | LINE_1);
        LCD_Send_String(" text would go here"); 
        break;
      }

      else
      {
          ;
      }

    }

}

Answer 1

这有点难以理解,因为您没有显示要"重新启动"的代码.

也许你可以在你展示的那个周围使用另一个循环:

while(1)
{
  code_that_is_restarted();
  while(1)
  {
    if(Default > Final) /* Very bad variable names */
    {
      break;  /* Exits the inner loop only. */
    }
  }
}

在break;将退出只有最内层的循环,所以程序将继续执行code_that_is_restarted();.