如何在 HP Proliant BL460c 刀片服务器上查看 HP Smart Array 固件版本

Question

查看 HP Smart Array 固件版本（最好是 GUI 版本）的最快方法是什么？我应该在 Windows 中查找还是可以通过 iLO 查看？

Answer 1

如果您安装了 HP Management Agents，该hpacucli实用程序（阵列配置软件的一部分）将提供您需要的所有控制器信息。对于 Windows 2003，请下载此命令行工具包 或此GUI 包。

该ctrl all show config detail指令将输出如下内容：

=> ctrl all 显示配置细节

Smart Array P410i in Slot 0 (Embedded)
   Bus Interface: PCI           
   Slot: 0                      
   Serial Number: 50123456789ABCDE
   Cache Serial Number: PBCDF0BRHYI032
   RAID 6 (ADG) Status: Disabled
   Controller Status: OK        
   Chassis Slot:                
   Hardware Revision: Rev C     
   Firmware Version: 5.12       
   Rebuild Priority: High       
   Expand Priority: High        
   Surface Scan Delay: 15 secs  
   Queue Depth: Automatic       
   Monitor and Performance Delay: 60 min
   Elevator Sort: Enabled       
   Degraded Performance Optimization: Disabled
   Inconsistency Repair Policy: Disabled
   Wait for Cache Room: Disabled
   Surface Analysis Inconsistency Notification: Disabled
   Post Prompt Timeout: 0 secs
   Cache Board Present: True
   Cache Status: OK
   Accelerator Ratio: 25% Read / 75% Write
   Drive Write Cache: Enabled
   Total Cache Size: 1024 MB
   No-Battery Write Cache: Enabled
   Cache Backup Power Source: Capacitors
   Battery/Capacitor Count: 1
   Battery/Capacitor Status: OK
   SATA NCQ Supported: True

   Array: A
      Interface Type: SAS
      Unused Space: 0 MB
      Status: OK